Hover over the image to zoom

Lime Green Ultra Insulating Base Coat Plaster

In stock

£16.09 + VAT

Lime Green's Ultra lime plaster base coat is a lightweight insulating lime plaster base coat that is five to ten times thermally more efficient than other lime plasters. This makes it the perfect plastering base coat for building renovations, where it gives an additional insulation layer to internal walls, protects against salt damage.

As an insulating lime plaster, Ultra Lime Plaster is such an effective insulator because it contains an aggregate of hollow beads made from recycled glass, which can make up to 55% of its bulk. This replaces the sand conventionally used in standard commercial lime plasters, which means Ultra Lime Natural uses less energy to manufacture and is significantly lighter to transport, so cutting down on distribution costs and energy.

Also, because it is applied as a wet plaster, Ultra Lime Plaster acts as a ‘draught excluder' by plugging any small pores and gaps within the fabric of the wall, something that standard dry-lining cannot do to the same extent.

Ultra lime plaster base coat is applied to walls in the same way as conventional lime plasters. It has good ‘workability' and there are no complicated fixings or problems achieving the right depth of coat.

You can buy Ultra lime plaster base coat directly from Lime Green or through a range of national merchants. And, as we maintain good stocks, you can be sure of a high level of availability even for larger projects



One bag of Ultra Lime plaster base coat will cover approx. 1.5m² at 10mm thick. This does not include any allowance for wastage.

Properly prepare the surface before application. Remove dust, surface contaminants and loose or friable coatings. Apply fungicide if necessary. On dense impervious backgrounds apply Lime green Natural Stipple for improved bond.

Ultra Lime plaster base coat can be mixed using a drum mixer, or in a tub using a plasterers paddle mixer. Spray render machines may also be suitable Always mix with clean water; do not add anything else.


Add approximately 4-4.5 litres. Mix for 5 to 10 minutes.

Temperatures: above 5°C and below 30°C.


Apply a coat of Ultra Lime Natural between 10 to 30 mm thick directly to dampened substrate. Each coat must be scratched while wet to give a good mechanical key before further coats are applied. If the substrate is very dry, dampen down the surface thoroughly prior to coating.

Use Lime Green Solo as the finish coat 2 to 7 days afterwards; once the coat has stiffened / hardened, but is still “green


upto 4 bag orders will be delivered via parcelforce

Orders for over 4 bags will delivered via our carriers TPN – The pallet network, please ensure that:

-      you have supplied us with as much information as possible about the access, location and facilities on-site - it is helpful if you have more than one contact phone number for the driver

-    we have been made aware of any access restrictions, the delivery depot will assume any size vehicle can deliver unless specified  (including low trees, bridges with weight limits, narrow entrances, restricted turning etc). Even if builder’s merchants, rubbish, skip lorries etc have had no problem, our curtain siders used by the pallet network may well have trouble with height especially, so give us as much information as possible ;

 -    The goods will be dropped by a tail-lift, Please note that a tail-lift requires a large, flat area of hard-standing (not gravel and not on an incline) to be able to offload

-    that you have organised enough space for the goods to be put

Please ring with any queries beforehand as a failed delivery due to lack of prior informartion will result in a re charge for delivery